NEC VERSA 6200MX Service Manual page 64

Table 2-4 POST Error Messages
MESSAGE
CMOS date and time
not set
CMOS memory size
mismatch
System CMOS
Checksum failure –
run Setup Press (F1)
to resume.
Fixed disk
configuration error
C: drive error or
failure
Hard Disk controller
failure
Keyboard controller
failure
Keyboard Error
KB\interface error
WHAT TO DO
Set the time and date using Setup. Exit and
save Setup changes to update the parameters.
Run Setup to reset the amount of memory
defined on the motherboard.
Press F2 to enter Setup. Under Exit, set the
default values. Under Main, set the date and
time. Save your changes and exit.
Start Setup. Exit and save to update the
parameters. Check to see if the hard disk
connector is seated properly. If there is still a
problem, the hard disk might need repair.
Press F2 to start Setup. Exit and save to update
the parameters.
Check to see if the hard disk connector is
seated properly.
If there is still a problem, the hard disk might
need repair.
Press F2 to start Setup. Exit and save to update
the parameters.
Check to see if the hard disk connector is
seated properly.
The hard disk controller does not work and
might need repair.
Unplug external keyboard if attached and
reboot the system. If it still fails, have the
system repaired.
NOTE
Repeated keystrokes during boot may
produce an error message .
A timing problem exists with the keyboard. If
the error message remains, the keyboard may
have to be repaired.
Error exists in keyboard connector. If the error
message remains, the keyboard may have to
be repaired.
Setup and Operation 2-23