Processor Removal; Processor Installation - NEC POWERMATE VE - SERVICE MANUAL 08-1996 Service Manual

3-14 Option Installation

Processor Removal

Remove the installed processor on the system board as follows.
Remove the system unit cover as previously described.
1.
2. Locate the processor socket (see Figure 3-8).
If any expansion boards are obstructing the socket, remove the boards.
3. Release the heatsink clip from the tabs on the socket.
Release the processor by pulling the lever on the socket away from the socket and
4.
as far back as it goes without forcing.
Lift the processor out of the socket.
5.

Processor Installation

1. Remove the processor currently in the system (described in the previous
procedure).
2. Align the notched corner of the processor with the alignment corner in the socket
and insert the processor.
3. Swing the lever down to lock the processor into the socket.
Install the heatsink on the processor and reattach the clip.
4.
Check to see if the newly installed processor requires a system board jumper
5.
change (see Appendix B, System Board Jumpers).
CAUTION: Before picking up the processor,
reduce static discharge by touching the metal
frame of the system unit.
CAUTION: Before picking up the processor,
reduce static discharge by touching the metal
frame of the system unit.
CAUTION: Remember to either reattach the
heatsink used with the old processor or install the
new heatsink supplied with the OverDrive
processor.