NEC POWERMATE VE - SERVICE MANUAL 08-1996 Service Manual page 80

3-24 Option Installation
Tabs
(behind front panel)
3. Identify the bay for the device being installed.
4. Remove the blank panel from the selected bay by pressing the panel tabs from
inside the front panel and pushing the blank panel out (see Figure 3-23).
5. Remove the perforated metal plate from the selected bay on the chassis by pulling
the metal plate back and forth until it releases.
Front Panel
Figure 3-22 Removing the Front Panel
Top Blank
Panel Tabs
Bottom Blank
Panel Tabs
Figure 3-23 Locating the Blank Panel Tabs
Blank Panel
Tabs
(behind front panel)