Removing The Front Panel - NEC POWERMATE CT User Manual

Firmly press the cover against the chassis and slide the cover towards
4.
the front of the chassis until it locks in place.
Note
check that the cover tabs at the front of the cover are properly inserted into
their slots in the chassis. Also check that the locking tab is inserted into its
slot on the back edge of the chassis.
Replace the two previously removed thumbscrews.
5.
If you have a padlock for the locking tab on the rear edge of the
6.
chassis, install it.
If your system is set up for use as a minitower, place the system
7.
upright.
Reconnect all external peripherals.
8.
Plug in your power cables.
9.

Removing the Front Panel

Remove the front panel if you are installing an internal 3 1/2-inch hard
drive or installing a device in one of the accessible device bays.
Remove the front panel as follows.
Remove the cover (see "Removing the Cover" earlier in this chapter).
1.
Position the system on its side on your work table, with the front
2.
panel over the edge of the table.
Working from inside the chassis, press up on the two front panel
3.
locking tabs to release them from their slots on the edge of the
chassis (see the following figure for tab location).
On the right side of the front panel, at the top corner, press in on the
4.
panel to release the top.
Pull out the top of the front panel while pulling up on the panel to
5.
release it from the chassis. Set the panel aside.
If the cover does not slide all the way to the front of the chassis,
Installing Options 4-7