NEC POWERMATE CT User Manual page 104

Remove the cover (see "Removing the Cover" earlier in this chapter).
1.
Locate the processor socket on the system board (see the figure
2.
"Locating the RIMM and processor sockets" earlier in this chapter).
and heat sink on the system board are hot. To avoid a burn, let the
components cool before continuing.
Tag and unplug the cooling fan cable from its connector (CPU Fan)
3.
on the system board.
Remove the fan, heat sink, and retention clip from the processor as
4.
follows (see the following figure).
Simultaneously press down on the flange on the end of the
!
retention clip while carefully pulling out the end to unhook it
from the tab on the processor socket.
Unhook the retention clip from the tab on the opposite side of the
!
processor socket.
Remove the fan, heat sink, and retention clip from the processor.
!
Remove the processor as follows.
5.
Pull out on the processor socket lock lever just enough to release
!
the lever from the socket, then pivot the lever up to release the
processor.
Carefully lift up on the processor and remove it from the socket.
!
Store the processor in a static-free bag.
If the system was just running, the processor
Installing Options 4-23