Startup - NEC POWERMATE CT User Manual

Set the voltage switch correctly for your area. The correct setting for
!
the U.S. and Canada is 115V.
Connect system power cables to a surge protector (recommended) or a
!
properly grounded wall outlet.
to a surge protector.

Startup

Press the power button to start up your system. The power lamp lights
green to indicate that the system is on. The system performs its
Power-On Self-Test (POST) and several messages appear indicating that
your system is checking its subsystems. To see the messages, press
during POST.
At the bottom of the NEC startup screen, the following message appears:
If you want to enter the BIOS Setup, immediately press
startup screen displays.
One beep indicates that the system has successfully completed the
power-on test.
After a short delay, Windows starts up.
If a problem occurs, a series of beeps may sound. If this happens
repeatedly after powering on, power off the system and turn to Chapter 5,
"Solving System Problems." The chapter provides helpful hints for
solving system problems.
Set the voltage switch correctly for your area.
NECC recommends connecting the power cable
Press F2 to enter BIOS Setup
F2
Setting Up the System 2-3
Esc
while the