A – 3 1/2-Inch Internal Bays
B – 3 1/2-Inch Accessible Bays
Preparing the Device
Before installing a storage device in the system, follow any preinstallation
instructions that come with the device. For example, check the following:
IDE hard drive — check the jumper settings on the device before
!
installing it. See the documentation that comes with the device for
jumper setting information. Cable correctly as the first (master) device
or second (slave) device on the primary IDE channel, depending on
your system configuration (see the table "IDE Connector
Configuration" later in this section).
CD-ROM drive, DVD-ROM drive, CD-RW drive — check the
!
jumper settings on the device before installing it. See the
documentation that comes with the device for jumper setting
information. Cable correctly as the first (master) or second (slave)
device on the secondary IDE channel (see the table "IDE Connector
Configuration" later in this section).
Locating device bays
C – 5 1/4-Inch Accessible Bays
Installing Options 4-27