NEC POWERMATE CT User Manual page 78

Function Jumper
BIOS JP5
Recovery
USB Port JP27,
Selection JP28
Front USB JP21
Device
Wakeup
Setting System Board Jumpers
Setting
1-2
2-3
1-2
1-2
2-3
2-3
2-3
1-2
Description
Factory setting. Sets the system for
normal operation. The BIOS uses
current configuration information and
passwords at power on.
To enable BIOS recovery for a
corrupted system, remove the jumper.
Wait 10 seconds. Replace the jumper
on pins 1 and 2.
Restores Safe BIOS settings as the
default BIOS settings and loads the
BIOS Setup at power on.
Factory setting. Enables the front USB
port and rear USB port.
Disables the front USB port and
enables the rear USB port.
Factory setting. Disables system
wakeup from the USB device
connected to the front USB port.
Enables system wakeup from the USB
device connected to the front USB port.
Configuring the System 3-41