Troubleshooting - CanyCom S300 Operator's Manual

Troubleshooting

• If any malfunction or abnormal condition is found, immediately stop using the
machine and take an appropriate measure according to the Troubleshooting chart
below. If the malfunction or abnormal condition is not listed in the chart, or the
suggested measure does not solve the problem, consult with your CANYCOM
representative.
• Some corrective measures listed below require special knowledge and/or equipment.
Please contact your CANYCOM representative in such a case.
Area
Engine does not
start,
or is difficult to start
Engine
Engine stalls
Troubleshooting
Malfunction
Out of fuel.
Air in fuel system.
Water in fuel.
Battery is
discharged.
Battery cable is
disconnected.
Bad connection
or breakage in the
wiring.
Starter switch,
relay or motor is
defective.
Insufficient or
wrong oil.
Other (other than
the above).
Out of fuel.
Air in fuel system.
Cold engine.
Other (other than
the above).
Possible Cause
-91-
Corrective Measure
→Fill fuel.
→Bleed air.
→Drain water.
→Add battery fluid
→Charge battery.
→Replace battery.
→Connect battery
cable.
→Please contact
your CANYCOM
representative.
→Please contact
your CANYCOM
representative.
→Fill or change oil.
→Please contact
your CANYCOM
representative.
→Fill fuel.
→Bleed air.
→Warm up engine.
→Please contact
your CANYCOM
representative.
6
Ref.
Page 28
Page 65
Page 47
Page 80
Page 57
Page 28
Page 65