Carrier bryant Evolution Connex Control SYSTXBBECC01-C Installation Instructions Manual page 72

Touch DEALER LOGO to upload the dealer logo and contact
information from a USB C connected to the Evolution Connex Control.
The "Dealer Logo Application" PC/MAC Desktop application download
available at www.MyEvolutionConnex.Bryant.com is required to
properly format the dealer logo and contact information for use on the
wall control.
Along with the dealer logo (if any), three lines of dealer information are
provided on the wall control:
Dealer name (50 characters, max)
Dealer phone number (20 characters, max)
Dealer URL (50 characters, max)
The wall control dealer information display is 30 characters wide. Dealer
names and URLs over 30 characters will be split into two lines on the
display.
The PC/MAC Desktop application to format the dealer logo and contact
information can be found at:
www.MyEvolutionConnex.Bryant.com
Download the program and follow the program instructions.
Once the dealer logo and contact information have been properly loaded
onto the storage device into the USB-C port on the side of the system
control, the control will prompt you whether or not to upload the dealer
logo . Once complete, you will receive a confirmation that your upload
was successful. If the information was not stored properly on the USB C
drive, you will receive an error message that the dealer logo was not
found. Refer back to the PC/MAC Desktop application instructions and
try again. Once the upload is complete, touch NEXT.
If you have problems, contact your distributor service manager for
support.
72