Carrier bryant Evolution Connex Control SYSTXBBECC01-C Installation Instructions Manual page 27

still detects a damper problem, it will default the measurements into
equal sizes, with 10% leakage, and display the zone number for the
suspected zone damper.
NOTE: The daily duct assessment will occur even if static pressure
monitoring is disabled. This is done to ensure that the system will
continue to provide proper airflow for all installed equipment, since duct
system changes may occur at any time, such as opened or closed
registers.
After the duct assessment is complete, touch NEXT.
6. Service Menu
The Service menus contain a set of vital information. This information
enables the installer or service person to view a summary of what has
been installed, etc. This information is not covered in the Owner's
Manual.
To enter service menus, touch menu, then touch and hold the SERVICE
icon, for at least ten seconds, until the icon turns green. The following
screens are available in installation and service. To return to the previous
screen, touch BACK. To exit the Service menus, touch DONE.
NOTE: See the Owner's Manual for information regarding software
upgrades.
NOTE: The user "selection of temperature units" affects the user screens
only. The service screens use degree F only. The user "selection of
temperature units" is under the display icon on the main menu.
27