Cisco C1131X-8PLTEPW Series Hardware Installation Manual page 39

Install and Connect the Router
This chapter describes how to install and connect Cisco 1000 Series Integrated Services Router to LAN and
WAN networks.
Warning
Installing the Cisco 1000 Series Integrated Services Router involve these tasks:
•
•
•
•
•
•
•
Unpack the Router
Unpack the router only when you are ready to install it. If the installation site is not ready, to prevent accidental
damage, keep the chassis in its shipping container until you are ready to install.
The router, accessory kit, publications, and any optional equipment you order may be shipped in more than
one container. When you unpack the containers, check the packing list to ensure that you have received all
the listed items.
Set up Router on Desktop, Rack, or Wall
After unpacking, based on your requirements, you can set up a Cisco 1000 Series Integrated Services Router
on a desktop, a rack, or the wall.
Read the installation instructions before using, installing or connecting the system to the power source.
Statement 1004
Unpack the Router, on page 33
Set up Router on Desktop, Rack, or Wall, on page 33
Connect Power Cable, on page 61
Connect the Router to a Console, on page 63
Install the Silicon Labs USB Device Driver, on page 67
Connect WAN and LAN Interfaces, on page 68
Configure the Router at Startup, on page 69
Hardware Installation Guide for the Cisco 1000 Series Integrated Services Router
3
C H A P T E R
33