Using Pconsole To Select A File Server; Creating Print Queues - Ricoh fax3310l Basic Features

4.1 Configuring NetWare 3.x
Note: You must have supervisor privileges to configure the queue. When you are finished,
turn the printer off and on again. The printer prints a status page that lists the file serv-
ers attached to the unit and the queues it services.
Before you begin:
• Verify that you have supervisor privileges on the file servers on which you are
entering the Network Interface Board print server and queue.
• Verify that your version of PCONSOLE is later than 1.0.

4.1.1 Using PCONSOLE to Select a File Server

1. Log in as a supervisor or ADMIN.
At the command prompt, enter the PCONSOLE command.
2.
Choose Change Current File Server from the Available Options menu.
3.
A list of file servers is displayed.
4. Select the file server on which you want to install the print server.
If the name of the file server you want is not displayed, type h to display a list of
file servers.
5. Log in to the file server.
6. Press the Esc key to return to the Available Options menu.

4.1.2 Creating Print Queues

A print server takes the print jobs from queues and sends them to the printer. The print
server must be assigned to at least one print queue on the file server.
If the print queue that you want the Network Interface Board to service already exists, and
you know the name of this queue, refer to Section 4.1.3 Entering the Print Server Name.
If you do not know the name of the queue or it does not exist, create a queue.
To create a queue:
1. In PCONSOLE, choose Print Queue Information from the Available Options
menu.
A list of existing queues is displayed.
Press the Insert key.
2.
3. Enter the name of the queue.
4-2 NetWare Configuration