Connecting The Interface Cables - ADIC DAT 160 Installation And Operating Manual

Connecting the Interface Cables

First make sure the interface cable you are using has the appropriate connectors on
each end. If the host computer's SCSI connector is different from that on the DAT
Autochanger, you will need to obtain a different cable than the one supplied with the
unit. Consult your dealer or adic Customer Assistance if you need help. Connect the
interface cables as shown in the following illustration and explained in the following
steps:
The interface cables must be shielded – adic can supply you
with the correct type(s).
p Check that the power switches on both the DAT Autochanger and the host
computer are off.
p Attach the 50-pin end of the SCSI interface cable to either connector on the rear
of the DAT Autochanger. Press firmly and secure the bail locks.
12
Connecting the DAT Autochanger
Note
Host Computer
SCSI Interface Cable
DAT Autochanger
Terminator