Cleaning The Enclosure - ADIC DAT 160 Installation And Operating Manual

If there are no more cleaning cycles remaining for the cleaning cassette,
the drive will eject it immediately after insertion.
p When the cleaning is finished the drive will automatically eject the cassette.
Remove the cleaning cassette and write the date on the label so you have a
record of how many times it has been used and when.
p To confirm that a cleaning was performed, look at the LEDs on the front of the
drive. If the cleaning cycle was successful, the LEDs will be off. If the cleaning
cycle was not performed (because the cleaning cassette was at its end-of-tape),
the LEDs will continue to flash.
p Place the magazine onto the carriage. Close the DAT Autochanger door. Press
LOAD to initiate the load procedure.
The DAT Autochanger is once again ready for use.

Cleaning the Enclosure

The outside of the enclosure can be cleaned with a damp towel. If you use a liquid
all-purpose cleaner, apply it to the towel. Do not directly spray the enclosure.
Note
Operation and Maintenance
31