Connecting the Interface Cables
DXU Y^dUbVQSU SQR\Uc ]ecd RU cXYU\TUT °
S_bbUSd di`Uc
Make sure the interface cable you are using has the appropriate connectors on each
end. If the host computer's SCSI connector is different from that on the VLS, you will
need to obtain a different cable than the one supplied with the unit. Consult your
DGLF
dealer or
shown in Figure 4 and explained in the following steps:
❐ Check that the power switches on both the VLS and the host computer are off.
❐ Attach one end of the SCSI interface cable to either connector on the rear of the
VLS. Press firmly and secure the bail locks.
10
Connecting the VLS
Customer Assistance if you need help. Connect the interface cables as
Term ina to r
SC SI
In terface
Ca ble
Figure 4. Connecting the Interface Cables
Note
DGLF
SQ^ ce``\i i_e gYdX dXU
V LS
H o s t C o m p u te r