Connecting The Interface Cables - ADIC VLS AIT Installation And Operating Manual

Connecting the Interface Cables

Make sure the interface cable you are using has the appropriate connectors on each end. If the
host computer's SCSI connector is different from that on the VLS, you will need to obtain a
different cable than the one supplied with the unit. Consult your dealer or ADIC Customer
Assistance if you need help. Connect the interface cables as shown in Figure 4 and explained
in the following steps:
❐
Check that the power switches on both the VLS and the host computer are off.
❐
Attach one end of the SCSI interface cable to either connector on the rear of the VLS.
Press firmly and secure the jack screws.
10
Connecting the VLS
Note
Term ina tor
SCS I
Interface
Cab le
Figure 4. Connecting the Interface Cables
V L S
H o s t C o m p u te r