Connecting The Interface Cable; Connecting More Than One Ait-70 D /100 D - ADIC AIT 100D Installation And Operating Manual

Connecting the Interface Cable

The jack screws at both ends of the SCSI interface cable must
be securely fastened to insure that the AIT-70
communicates properly with the host computer.
Attach a shielded interface cable between the host adapter and your AIT-70
will need depends on the kind of SCSI bus connector on your host adapter. The AIT-70
contact, shielded, high-density SCSI device connector.
4
Make sure that the SCSI cable between the host adapter and the AIT-70
connections are fastened correctly.
Connecting More than One AIT-70
If you are connecting more than one AIT-70
the previous unit with an additional shielded interface cable. It doesn't matter which SCSI connector on each
AIT-70 /100 you connect the interface cable to. Figure 5 shows a sample configuration.
D D
Note
D
/100
/100 on the same SCSI channel, simply connect each unit to
D D
SCSI Cables
Host
Computer
Figure 5. 4 AIT-70 /100
D
/100
D D
/100
D D
/100
D
D
Units Daisy-chained
D
Hardware Installation
. The kind of cable you
/100 has a 68-
D D
is secure and the
D
Terminator
4
AIT-70D/100D
Units
Daisy-chained
9