Viewing Network Status - Server Technology PRO2 Switched POPS STV-6542 User Manual

Viewing Network Status

You can obtain the IPv6 network status through the firmware Web Interface or Command Line Interface (CLI). For
the CLI, use the show network command as follows:
Switched CDU: show network
Network Configuration
State:
Link:
Speed:
MAC:
AutoCfg IPv6:
IPv4 Address:
IPv4 Gateway:
DNS1:
DNS2:
Static IPv4/IPv6 Settings
IPv6 Address:
IPv6 Gateway:
IPv4 Address:
IPv4 Gateway:
DNS1:
DNS2:
DHCP Settings
DHCP:
FQDN:
Boot Delay:
Static Fallback: disabled
Network Services
FTP Server:
FTP Updates: disabled
SSH:
Telnet:
HTTP:
HTTPS:
User Cert: Disabled
SNMPv1/2:
SNMPv3:
SPM Access:
Note: The fields IPv4 Address, IPv4 Subnet Mask, IPv4 Gateway, DNS1, and DNS2 are equivalent to existing
PRO2 IPv4 settings except that current network settings and static settings are displayed separately.
This allows you to view both static configuration settings and active network settings that can be obtained
using DHCP. The DNS addresses may be in IPv4 or IPv6 (based on RFC4291) format at this time.
Getting Started with the Firmware
Static IPv4 Network:
Up Negotiation:
100 Mbps Duplex:
00-0A-9C-60-0029
FE80::20A:9CFF:FE60:29/64
10.1.2.65 Subnet Mask:
10.1.1.1
10.1.5.133
10.1.5.134
::/64
::
10.1.2.65 Subnet Mask:
10.1.1.1
10.1.5.133
10.1.5.134
disabled
enabled [sentry-600029]
disabled
enabled Port: 21
Port: 21
enabled Port: 22
enabled Port: 23
enabled Port: 80
enabled Port: 443
enabled Port: 161
disabled Port: 161
enabled
Switched PRO2 – User Guide
Dual IPv6/IPv4
Auto
Full
255.255.0.0
255.255.0.0
Auth: Password, Kb-Int
Installed Cert: Self Generated
Stored Files: None
User Passphrase: (none)
TrapPort: 162
TrapPort: 162
•
25