Server Technology PRO2 Switched POPS STV-6542 User Manual page 178

Sub-Parameters
The set unit command uses the following sub-parameters:
Command Access
Admin level only
set ups
Sets UPS device configuration values.
Command Syntax
set ups addline <UPS#> <line name | id | ALL>
set ups commstr <UPS#> <get community string>
set ups delline <UPS#> <line name | id | ALL>
set ups host <UPS#> <hostname>
set ups oidspoll <UPS#> <oid>
set ups onbattery <UPS#> <value>
set ups onutility <UPS#> <value>
set ups port <UPS#> <port>
set ups type <UPS#> <value>
Parameters
The set ups command uses the following parameters:
Using the Command Line Interface (CLI)
identify Set to enable/disable flashing display.
name The name of the unit. 0-32 characters.
osequence Sets the outlet sequence order for a unit.
prodsn Sets the product serial number for a unit. 0-32 characters.
purge Removes all stored information for a unit.
snmpt SNMP trap notifications for unit events.
auto Set automatic display orientation using internal orientation sensor.
Inverted Set display to be upside down.
normal Set display to be right-side up; set outlet sequencing to be 1 to n.
reversed Set outlet sequencing to be n to 1.
UPS# The number of the UPS to change. 1-8.
addline Adds the specified line to be protected by the UPS.
commstr Sets the community string for polling the UPS by SNMP. 0-32
characters.
delline Removes the specified line from a UPS.
host Hostname for polling the UPS by SNMP. 0-63 characters.
Switched PRO2 – User Guide
•
178