Server Technology PRO2 Switched POPS STV-6542 User Manual page 156

set dhcp
Sets DHCP configuration values.
Command Syntax
set dhcp [disabled | enabled]
set dhcp fqdn [disabled | enabled]
set dhcp fqdn name <name>
set dhcp staticfallback [disabled | enabled]
set dhcp bootdelay [disabled | enabled]
Parameters
The set dhcp command uses the following parameters:
Sub-Parameters
The set dhcp command uses the following sub-parameter:
Command Access
Admin level only
set dns
Sets domain name system (DNS) server configuration values.
Command Syntax
set dns [primary | secondary] <ipv4/ipv6>
Parameters
The set dns command uses the following parameters:
Command Access
Admin level only; no access in Demo mode
Using the Command Line Interface (CLI)
fqdn Fully-qualified domain name (FQDN).
staticfallback Falls back to static IP address if DHCP fails.
Note: The staticfallback option does not apply when WLAN is
enabled.
bootdelay Delays system boot by 100 seconds.
name FQDN name. 0-63 characters.
primary Sets the first DNS server. 0-46 characters.
secondary Sets the secondary DNS server. 0-46 characters.
Switched PRO2 – User Guide
•
156