Set Location - Server Technology PRO2 Switched POPS STV-6542 User Manual

Parameters
The set loadshed command uses the following parameters:
Sub-Parameters
The set loadshed command uses the following sub-parameters:
Usage Guidelines
The Smart Load Shedding feature must be enabled.
Command Access
Admin level only

set location

Sets the system location string.
Command Syntax
set location <location string>
Parameters
The set location command uses the following parameter:
Command Access
Admin level only
Using the Command Line Interface (CLI)
branch Sets to allow branch shedding events.
line Sets to allow line shedding events.
sensor Sets to allows sensor shedding events.
ups Sets to allow UPS shedding events.
all Sheds outlets only when all UP devices on an upstream line go to "on
battery".
any Sheds outlets when any UPS device on an upstream line goes to "on
battery".
recoverdelay The delay that a UPS device needs to be "on utility" before recovering
outlets. 0-10 minutes.
recovery off Shed outlets are not recovered Does not recover shed outlets when
even conditions are cleared.
recovery on Automatically recover shed outlets when event conditions are cleared.
sheddelay The delay that a UPS device needs to be "on battery" before shedding
outlets. 0-10 minutes.
location string Location string text for system location. 0-63 characters.
Switched PRO2 – User Guide
•
164