Set Radius - Server Technology PRO2 Switched POPS STV-6542 User Manual

Parameters
The set port command uses the following parameters:
Command Access
Admin level only

set radius

Sets Radius server configuration values.
Command Syntax
set radius [primary | secondary] port <port>
set radius [primary | secondary] retries <retries>
set radius [primary | secondary] host <hostname>
set radius [primary | secondary] secret <shared secret>
set radius [primary | secondary] timeout <timeout>
Parameters
The set radius command uses the following parameters:
Command Access
Admin level only; No access in Demo mode
Using the Command Line Interface (CLI)
baud/speed Sets the number of symbols per second of the serial port.
dsrcheck Sets to use DSR before making a serial connection.
timeout Sets the connection idle timeout for pass-thru connections to this port.
0-60 minutes (default 5 minutes).
primary Sets the first Radius server.
secondary Sets the second Radius server.
port Sets the port for Radius sever connections. 1-65535 (default 1812).
retries Set the maximum retry count for the Radius server. 0-10 (default 2).
host Sets the Radius server hostname. 0-63 characters.
secret Sets the shared secret value for the Radius server. 0-48 characters.
Note: The secret that was set for the primary server will not be cleared
when setting the secret for the secondary server, and vice versa.
timeout Sets the connection timeout for the Radius server. 1-30 seconds
(default 5 seconds).
Switched PRO2 – User Guide
•
170