Server Technology PRO2 Switched POPS STV-6542 User Manual page 158

Sub-Parameters
The set email command uses the following sub-parameters:
Command Access
Admin level only; no access in Demo mode
set energywise
Sets Cisco EnergyWise configuration values.
Command Syntax
set energywise [disabled | enabled]
set energywise port <UDP port>
set energywise domain <domain name>
set energywise refresh <refresh rate>
set energywise secret <secret key>
Parameters
The set energywise command uses the following parameters:
Command Access
Admin level only; no access in Demo mode
Using the Command Line Interface (CLI)
userfromaddr Sets to log into the relay SMTP server using the from address.
username Sets the username for logging into the relay SMTP server.
0-32 characters, spaces are not allowed.
test Tests the email setting for logging into the relay SMTP.
usesubjloc Uses the location string as the subject of the relayed emails.
usesubjdef Uses the default subject as the subject of the relayed emails.
(sentry@macoui).
useusername Set to log into the relay SMTP server using the SMTP username.
any Uses any of the authentication methods described in this table.
crammd5 Uses only CRAM-MD5 for authentication.
digestmd5 Uses only Digest MD5 for authentication
login Uses only login authentication.
plain Uses only plain authentication.
none Uses only no authentication.
port Sets the port number of the EnergyWise host. 1-65535 (default 43440).
domain Sets the domain of the EnergyWise host. 0-63 characters.
refresh Sets the refresh rate that sends new EnergyWise discovery packets.
30-600 seconds.
secret Sets the secret key for the EnergyWise server. 0-80 characters.
Switched PRO2 – User Guide
•
158