Server Technology PRO2 Switched POPS STV-6542 User Manual page 173

Sub-Parameters
The set snmp command uses the following sub-parameters:
Command Access
Admin level only; No access in Demo mode.
Using the Command Line Interface (CLI)
dest1 First SNMP trap destination. 0-63 characters.
dest2 Second SNMP trap destination. 0-63 characters.
format Format of SNMP trap and header.
repeat Sets the SNMP trap repeat time for object in an event condition. 1-
65535 seconds.
getcomm Read community string for SNMPv2. 0-32 characters. Default is public.
setcomm Read/write community string in SNMPv3. 0-32 characters. Default is
blank.
trapcomm Community string in SNMPv2 traps for authentication. 0-32 characters.
ro-prefix Read-Only SNMPv3 user.
rw-prefix Read/write SNMPv3 user.
auth Authentication type for an SNMPv3 user.
authpass Authentication password for an SNMPv3 user. 0-39 characters.
privpass Privacy password for an SNMPv3 user. 0-31 characters.
username Username for an SNMPv3 user. 0-31 characters.
trapusername Username for trap authentication for SNMPv3 traps. 0-31 characters.
none No authentication or privacy is used (authpass and privpass are not
used).
md5 Authentication but not privacy is used (privpass is not used).
md5des Authentication and privacy are used
Switched PRO2 – User Guide
•
173