Server Technology PRO2 Switched POPS STV-6542 User Manual page 187

show loadshed
Shows load shedding configuration values.
Command Syntax
show loadshed
Command Access
Admin level only
Example
Switched CDU: show loadshed
Using the Command Line Interface (CLI)
General load shedding options:
UPS On-Battery Load Shedding:
UPS On-Utility Auto Recovery:
Line Load Shedding:
Branch Load Shedding:
Sensor Load Shedding:
Line shedding event settings:
ID Line Name
-- ---------
AA1 AA:L1
BA1 BA:L1
Sensor shedding event settings:
ID Sensor Name
-- -----------
E1 Contact_Sensor_E1
E2 Contact_Sensor_E2
E3 Contact_Sensor_E3
E4 Contact_Sensor_E4
A1 Temp_Sensor_A1
A2 Temp_Sensor_A2
B1 Temp_Sensor_B1
B2 Temp_Sensor_B2
E1 Temp_Sensor_E1
E2 Temp_Sensor_E2
E1 Water_Sensor_E1
Outlet load shedding events:
ID Outlet Name
AA1 Master_Outlet_1
AA2 Master_Outlet_2
AA3 Master_Outlet_3
AA4 Master_Outlet_4
AA5 Master_Outlet_5
Switched PRO2 – User Guide
Status Action Delay
disabled 0 minute(s)
enabled 0 minute(s)
disabled
disabled
disabled
On-Bat Shed High Current
----------- ------------
disabled 24.0A
disabled 24.0A
Type Auto-Rec High Temp
---- -------- ---------
CS disabled --
CS disabled --
CS disabled --
CS disabled --
TS disabled 50C
TS disabled 50C
TS disabled 50C
TS disabled 50C
TS disabled 50C
TS disabled 15C
WS disabled --
-Enabled Load-Shed Events-
UPS Line Branch
- - -
- - -
- - -
- - -
- - -
•
187