Server Technology PRO2 Switched POPS STV-6542 User Manual page 165

set net
Sets network mode configuration values.
Command Syntax
set net [disabled | ipv4only | dualv6v4]
Parameters
The set net command uses the following parameters:
Command Access
Admin level only; no access in Demo mode.
set ocp
Sets over-current protector (OCP) configuration values.
Command Syntax
set ocp email [disabled | enabled] <name | id | ALL>
set ocp loadmax <name | id | ALL> <value>
set ocp snmpt [disabled | enabled] <name | id | ALL>
Parameters
The set ocp command uses the following parameters:
Command Access
Admin level only
Using the Command Line Interface (CLI)
disabled Disables network access to system.
ipv4only System only allows IPv4 functionality.
Dualv6v4 System allows IPv6 and IPv4 functionality.
email Email notifications for OCP events.
loadmax Maximum current load for an OCP. Valid range is 1 to "max factory
current" from the show ocps command.
snmpt SNMP trap notifications for OCP events.
Switched PRO2 – User Guide
•
165