Download Print this page

Server Technology PRO2 Switched POPS STV-6542 User Manual page 172

Advertisement

Sub-Parameters
The set sensor command uses the following sub-parameters:
min <= alarmlo <= warnlo <= warnhi <= alarmhi <= max
Command Access
Admin level only
set snmp
Sets SNMP configuration values.
Command Syntax
set snmp iprestrict [none | trapdests]
set snmp syscontact <system contact>
set snmp syslocation <location>
set snmp sysname <system name>
set snmp trap dest1 <hostname>
set snmp trap dest2 <hostname>
set snmp trap format [v1 | v2c | v3]
set snmp trap repeat <repeat time>
set snmp v2 [disabled | enabled]
set snmp v2 [getcomm | setcomm | trapcomm] <comm string>
set snmp v3 [disabled | enabled]
set snmp v3 [roauth | rwauth] [none | md5 | md5des]
set snmp v3 [roauthpass | rwauthpass] {password} verify password}
set snmp v3 [roprivpass | rwprivpass] {password} {verify password}
set snmp v3 [rousername | rwusername | trapusername] <username>
Parameters
The set snmp command uses the following parameters:
Using the Command Line Interface (CLI)
alarmhi
Sets high alarm value.
alarmlo
Sets low alarm value.
warnhi
Sets high warning value.
warnlo
Sets low warning value.
iprestrict
Sets to only allow to trap destinations to have SNMP access
syscontact
System contact string. 0-63 characters.
syslocation
System location string. 0-63 characters.
sysname
System name string. 0-63 characters.
trap
Sets trap notification options.
v2
Sets to allow access with SNMPv2.
v3
Sets to allow access with SNMPv3.
Switched PRO2 – User Guide
172

Advertisement

loading
Need help?

Need help?

Do you have a question about the PRO2 Switched POPS STV-6542 and is the answer not in the manual?

Subscribe to Our Youtube Channel