Removing The Cd Drive - HP b2600 Technical Reference

Remove/Replace System Components
Removing/Replacing System Components

Removing the CD Drive

To remove the CD drive, follow this procedure:
1. Complete the procedure in the section "Removing the Front Bezel and Top Cover"
found in this chapter.
2. Disconnect the CD drive control cable by pulling up on its pull tab and disconnect the
power cable by pressing in on its latch release. See Figure 3-8.
Figure 3-8. Disconnecting the CD Drive Control Cable
CD Drive
Control Cable
3. Disconnect the audio-extender cable and the CD drive audio cable by pressing in on the
audio-extender cable's latch release. See Figure 3-9. Also, lift up on the PCI cage audio
retainer tabs to remove the audio cable from the PCI cage. Note that you can skip this
section if your workstation does not have an audio card.
Figure 3-9. Disconnecting the Audio-Extender Cable
Disconnect
Audio Cable
Here
Audio-Extender
Cable
Audio
Retainer
Tabs
Audio Cable
46
CD Drive Power Cable
Chapter 3