HP b2600 Technical Reference page 84

Remove/Replace System Components
Removing/Replacing System Components
4. Plug the two fan-module power cable's connectors into their connectors on the system
board. See Figure 3-72.
Figure 3-72. Plugging the Fan-Module Power Cables into the System Board
System Area
System Board
5. Insert the LCD connector into its slot on the workstation's chassis and screw in the
LCD connector screws. See Figure 3-73.
Figure 3-73. Replacing the LCD Connector
LCD Connector Slot
6. Complete the procedure in the section "Replacing the Liquid Crystal Display"
found in this chapter.
7. Complete the procedure in the section "Replacing the Front Bezel and Top Cover"
found in this chapter.
8. Connect and turn on the power to your system.
9. Determine that your system area fan-module replacement was successful by checking
the workstation's LCD for fan error messages. If LCD fan error messages appear, repeat
this procedure. If your LCD still displays fan error messages, contact your local HP
Support Representative.
84
LCD Connector
Fan Module
Fan-Module Power Cables
LCD Connector Screws
Chapter 3