HP b2600 Technical Reference page 156

HP B2600 Chassis Codes
Chassis Codes
Table C-1. Chassis Codes for B2600 Workstations
Ostat Code FRU
FLT 7309 DIMM
FLT 730C SYS BD
INI 730F SYS BD
TST 7400 DIMM
TST 740F DIMM
INI 7500 SYS BD
WRN 7501 SYS BD
FLT 7502 SYS BD
TST 7600 DIMM
WRN 7601 DIMM
TST 7602 DIMM
TST 7603 DIMM
TST 7604 DIMM
TST 7605 DIMM
TST 7606 DIMM
TST 7607 DIMM
TST 7608 DIMM
TST 7609 DIMM
TST 760A DIMM
TST 760B DIMM
WRN 760C DIMM
FLT 760D DIMM
FLT 7610 DIMM
156
Message
insufficient mem
mem intrlv fail
mem config done
non-dest mem tst
non-dst tst done
memory reset
mem log clr warn
mem err log fail
dest mem test
mem init only
tst 1st mem page
tst rest of mem
start 1st pass
1st pass x%
start 2nd pass
2nd pass x%
start 3rd pass
3rd pass x %
start mem init
mem init x%
repeat dest test
mem code cpy err
ECC wrt/read err
Description
Insufficient error-free memory to
continue.
Memory interleave generation failed.
Main memory configuration complete.
Starting non-destructive memory test.
Non-destructive memory test complete.
Resetting memory system.
Memory error logs didn't clear on first try.
Firmware could not clear memory error
logs.
Starting the destructive memory test.
Skip the test, just initialize memory to
save time.
Starting 3-pass test of first memory page.
Starting 3-pass test of the rest of memory.
Starting 1st pass of memory test (write
pseudorandom sequence).
First pass is x% complete.
Starting 2nd pass of memory test (verify
pseudorandom sequence, write inverse).
Second pass is x% complete.
Starting 3rd pass of memory test (verify
inverse sequence).
Third pass is x% complete.
Starting memory initialization. (Initialize
to zero to set ECC.)
Memory initialization is x% complete.
Re-execute destructive test for hardware
troubleshooting.
Firmware tried to copy code from ROM to
memory, but the copy didn't match the
original.
Writing and reading back good data
caused memory ECC error.
Appendix C