Removing The Flexible Disk Drive - HP b2600 Technical Reference

Remove/Replace Flexible Disk Drives

Removing the Flexible Disk Drive

Removing the Flexible Disk Drive
To remove the flexible disk drive, follow the procedure in this section. Note that this procedure
assumes you already have a SCSI card and cable installed in your system.
Complete the procedure in the section "Removing the Front Bezel and Top Cover" found in
1.
Chapter 3.
2. Disconnect the flexible disk drive power cable from the system board by pressing in on the power
cable connector's latch release. See
Figure G-1 Disconnecting the Flexible Disk Drive Power Cable
3. Remove the flexible disk drive and flexible disk drive bay area from the workstation by pressing
in on both flexible disk drive retainer clips and pull outward. See
Figure G-2 Remove the Flexible Disk Drive and Flexible Disk Drive Bay
Flexible Disk Drive
Retainer Clip
196
.
Figure G-1
Power Cable
Connector
Figure G-2.
Flexible Disk Drive
Retainer Clip
Appendix G