Removing The Scsi Cable - HP b2600 Technical Reference

8. Unscrew the four bracket mounting screws from the flexible disk drive and remove the flexible
disk drive from its bracket. See
Figure G-7 Unscrew the Four Flexible Disk Drive Mounting Screws
Bracket Mounting Screws

Removing the SCSI Cable

Because there are special considerations you should know regarding the removal of the SCSI cable,
this section explains some of those considerations. This section also explains how to remove the
SCSI cable from your workstation's PCI cage.
Here are some important points to remember regarding the SCSI card and cable.
• The SCSI card can be installed in any of the unused slots in your workstation's PCI cage;
however, for ease of cable routing it is best to install your SCSI card in slot 4 of the PCI cage.
• The SCSI cable is long enough to allow you to run it through the flexible disk drive bay and out
its front. This makes it easy for you to connect your power and SCSI cable connectors to the
flexible disk drive.
The connectors on both ends of the SCSI cable are keyed to allow for proper pin connection.
•
However, the flexible disk drive's connector is not keyed and you have to align the red line on
the SCSI cable with the left side (as viewed from the back of the flexible disk drive) of the flexible
disk drive's SCSI connector.
To remove the SCSI card and cable, follow this procedure:
Complete the procedure in the section "Removing the Flexible Disk Drive" found in this
1.
appendix.
Appendix G
Figure G-7.
Bracket Mounting Screws
Remove/Replace Flexible Disk Drives
Removing the Flexible Disk Drive
Flexible Disk Drive
Flexible Disk Drive
Bracket
199