Removing The Dat Drive - HP b2600 Technical Reference

Remove/Replace DAT Drives

Removing the DAT Drive

Removing the DAT Drive
To remove the DAT drive, follow the procedure in this section. Note that this procedure assumes
you already have a SCSI card and cable installed in your system.
Complete the procedure in the section "Removing the Front Bezel and Top Cover" found in
1.
Chapter 3.
2. Disconnect the DAT drive power cable from the system board by pressing in on the connector's
latch release. See
Figure F-1 Disconnecting the DAT Drive Power Cable
3. Remove the DAT drive and DAT drive bay from the workstation by pressing in on both DAT
drive retainer clips and pull outward. See
Figure F-2 Remove the DAT Drive and DAT Drive Bay Area
SCSI Cable
DAT Drive
Retainer Clip
184
.
Figure F-1
.
Figure F-2
Power Cable
Connector
Power Cable
DAT Drive
Retainer Clip
Appendix F