Replacing The Ac Or Dc Power Supply - HP b2600 Technical Reference

Remove/Replace System Components
Removing/Replacing System Components

Replacing the AC or DC Power Supply

You can choose to have either an AC or DC power source when ordering a HP B2600
workstation. The AC power source is suitable for most of your computing needs.
This section covers how to replace the AC power supply. To learn how to replace the DC
power supply, see Appendix E in this document.
To replace the AC power supply, follow this procedure:
1. Remove the AC power supply if you have not already done this. Otherwise, skip this
step. To remove the AC power supply, follow the procedure in the section "Removing
the AC or DC Power Supply" found in this chapter.
2. Replace the AC power supply in the workstation. To do this, you will have to slide the
power supply's support arm into its slot on the system divider panel. See Figure 3-50.
Figure 3-50. Replacing the AC Power Supply
3. Align the four threaded screw holes on the power supply with their screw holes on the
workstation's chassis and screw in the four mounting screws. See Figure 3-51.
Figure 3-51. Screwing in the Four Power Supply Mounting Screws
70
System Divider
Power Supply
Panel
Power Supply Mounting Screws
Support Arm
Power Supply
Support Arm
System Divider
Panel
Chapter 3