HP b2600 Technical Reference page 71

4. Push the power supply cable's connectors into their connectors on the system board. See
Figure 3-52.
Figure 3-52. Connect the Power Supply Cables
System Divider
Panel
Power Supply
Cables
System Board
5. Complete the procedure in the section "Replacing the Front Bezel and Top Cover"
found in this chapter.
6. Connect and turn on the power to your system.
7. Determine that your AC power supply replacement was successful by observing to see if
the workstation's LCD lights up and the CDE login screen appears in your
workstation's display. If your workstation's LCD does not light up and the CDE login
screen does not appear, repeat this procedure. If your workstation's LCD still does not
light up and the CDE login screen does not appear, contact your local HP Support
Representative.
Chapter 3
Remove/Replace System Components
Removing/Replacing System Components
Support Arm
Power Supply
Component
Heat Sink
71