6.10.1 After Work - Labconco ReVo User Manual

Do not perform work while the fan is running at reduced speed.
•
The front window must be in work position.
•
• Place the product behind the perforated area of the work surface.
Work with calm, smooth movements.
•
Never overload the work chamber.
•
• Reduce the number of transfers into and out of the work chamber.
Avoid equipment with high heat emission.
•
Avoid a cabinet location where personnel frequently pass avoid draughts.
•
Caution
The efficiency of the laminar airflow in the work chamber is essential for personnel
and product protection. Negative influences of the flow conditions must therefore be
avoided.
They are primarily raised due to:
• Rapid movements of the operator's hand, arm, or body both in and in front of the work
chamber.
• Covered perforations in the table top, both at the front and the back of the work chamber.
Large objects and apparatus.
•
Devices making rapid movements, e.g. agitators, centrifuges.
•
Caution
Do not damage the laminator, the prefilters (ReVo Pro) or the main filter in the ceiling
of the work chamber by mechanical objects or heat sources, otherwise the
microbiological safety is no longer ensured.
The acoustic and optical monitoring devices of the fan and front window must not be deactivated.
Devices developing strong heat e.g. burners which can disrupt airflows.
Operate heat sources only with the cabinet fan activated.

6.10.1 After work

Remove objects and appliances from the work chamber.
Clean the work chamber, remove fluids, if any, from the trough and dry it. Disinfect if required.
Leave the cabinet fan in operation for about another 10 minutes.
Close the front window to its lowest position.
32