Notes On Rack Mounting And Connecting A Powerstrip - Fujitsu xg0224 Safety And Installation Manual

Safety and Installation Guide
1.2 Notes on Rack Mounting and
Connecting a Powerstrip
If you mount this device on a rack, pay close attention to operation temperature management,
Warning
physical stability establishment and current leakage. This device must only be mounted on the rack
by a qualified engineer with the required knowledge. Failure to follow this may result in electric shock
or fire.
• Monitor and control the internal and external temperature and humidity of your rack, so that it does not exceed the
range of guaranteed operation temperature and humidity.
• This device uses a side inlet and side exhaust ventilation design. Install the device not to obstruct the inlet and exhaust
ventilation surfaces.
• Make sure to check the maximum loading capacity of the rack to be used for mounting.
• Check the power supply capability of the installation location.
• If you connect the power cable of this device to a powerstrip, a large amount of current leakage can occur through the
ground line of the strip. Make sure to establish a ground connection before connecting to the power. If the power cable
is not directly connected to the distribution board, you must use a powerstip with industrial use plugs (The maximum
current leakage for this device is 3.5mA).
7

Notes on Rack Mounting and Connecting a Powerstrip

Chapter 1 Safety Precautions