Cisco WS-C2350-48TD-S Command Reference Manual page 84

errdisable detect cause
Command History Release
12.2(46)EY
Usage Guidelines
A cause (link-flap, dhcp-rate-limit, and so forth) is the reason for the error-disabled state. When a
cause is detected on an interface, the interface is placed in an error-disabled state, an operational state
that is similar to a link-down state.
When a port is error-disabled, it is effectively shut down, and no traffic is sent or received on the port. For the
BPDU guard feature, you can configure the switch to shut down just the offending VLAN on the port
when a violation occurs, instead of shutting down the entire port.
If you set a recovery mechanism for the cause by entering the errdisable recovery global configuration
command for the cause, the interface is brought out of the error-disabled state and allowed to retry the
operation when all causes have timed out. If you do not set a recovery mechanism, you must enter the
shutdown and then the no shutdown commands to manually recover an interface from the
error-disabled state.
Examples
This example shows how to enable error-disabled detection for the link-flap error-disabled cause:
Switch(config)# errdisable detect cause link-flap
This command shows how to globally configure BPDU guard for per-VLAN error disable:
witch(config)#
S
You can verify your setting by entering the show errdisable detect privileged EXEC command.
Related Commands Command
show errdisable detect
show interfaces
clear errdisable interface
Catalyst 2350 Switch Command Reference
2-60
Modification
This command was introduced.
errdisable detect cause bpduguard shutdown vlan
status err-disabled
Chapter 2 Catalyst 2350 Switch Cisco IOS Commands
Description
Displays error-disabled detection information.
Displays interface status or a list of interfaces in the
error-disabled state.
Clears the error-disabled state from a port or VLAN that
was error disabled by the per-VLAN error disable feature.
OL-19055-01