Cisco WS-C2350-48TD-S Command Reference Manual page 198

mls qos trust
If you configure the trust setting for DSCP or IP precedence, the DSCP or IP precedence values in the
incoming packets are trusted. If you configure the mls qos cos override interface configuration
command on the switch port connected to the device, the switch overrides the CoS of the incoming
packets and assigns the default CoS value to them.
For an inter-QoS domain boundary, you can configure the port to the DSCP-trusted state and apply the
DSCP-to-DSCP-mutation map if the DSCP values are different between the QoS domains.
Classification using a port trust state (for example, mls qos trust [cos | dscp | ip-precedence] and a
policy map (for example, service-policy input policy-map-name) are mutually exclusive. The last one
configured overwrites the previous configuration.
Examples This example shows how to configure a port to trust the IP precedence field in the incoming packet:
Switch(config)# interface gigabitethernet0/1
Switch(config-if)# mls qos trust ip-precedence
You can verify your settings by entering the show mls qos interface privileged EXEC command.
Related Commands Command
mls qos cos
mls qos dscp-mutation
mls qos map
show mls qos interface
Catalyst 2350 Switch Command Reference
2-174
Description
Defines the default CoS value of a port or assigns the default CoS to all
incoming packets on the port.
Applies a DSCP-to DSCP-mutation map to a DSCP-trusted port.
Defines the CoS-to-DSCP map, DSCP-to-CoS map, the
DSCP-to-DSCP-mutation map, the IP-precedence-to-DSCP map, and the
policed-DSCP map.
Displays QoS information.
Chapter 2 Catalyst 2350 Switch Cisco IOS Commands
OL-19055-01