Install The Vesa Monitor Mount To A Monitor - StarTech.com 3M1A3SG-MONITOR-ARM User Manual

Install the VESA Monitor Mount to a Monitor

Warnings!
Do not overtighten the screws. If you encounter resistance,
stop tightening immediately. Failure to do so, could result in
damage to the Monitor(s).
Ensure the weight of the Monitor(s) does not exceed the
weight capacity of this product. Exceeding the weight
capacity may result in personal injury, damage to the
product, the attached equipment, and the mounting surface.
This product can support the following weight: Up to 13.2 lb
(6 kg) per mount.
Attaching the Monitor(s) is a two-person Job. Do not attempt
to complete this task alone.
The attached Monitor(s) may not be properly supported by
the Monitor Spring Arm until its spring mechanism is
correctly adjusted. Exercise caution to prevent rapid falling.
To avoid personally injury and equipment damage, always
exercise caution when releasing the Monitor(s) by supporting
its weight until a stable position is achieved.
To accommodate different monitor designs,
3M1A3SG-MONITOR-ARM comes with sets of screws of various
lengths and diameters (M4x12mm & M5x12mm), and washers.
Determine the Depth and Diameter of the VESA Mounting
1.
Holes on the Monitor(s), and select the appropriate
mounting hardware to attach the VESA Monitor Mount.
Carefully place the Monitor(s) face down on a protective/soft
2.
surface with the VESA Mounting Points facing up.
For additional self-service support options and community forums, please visit: www.StarTech.com/support
18