Danfoss iC7 Series Operating Manual page 18

iC7 Series Cooling Modules
Operating Guide
592
(23.31)
Illustration 6: Dimensions for the Cut-out on the Cabinet Door in mm, Dual-pump Cabinet
4. Optional: Install a new leaking pan into the cabinet.
a. Remove the standard leaking pan of the cooling module.
b. Detach the leakage sensor LS11 from the standard leaking pan of the cooling module and attach it into the new
cabinet leaking pan deep end.
c.
Install seals according to the protection rating.
d. Install the new leaking pan with an inclination forward.

More space is gained.
5. If the standard leaking pan of the cooling module is used, the cabinet floor must have sealing that meets the requirements
of the protection rating.
6. Attach the cooling module into the cabinet frame using the all the specified mounting holes.
See the location of the mounting holes in
Dimensions of the Dual-pump Standalone Cooling
The installation must be rigid. A good installation prevents the product from moving or being damaged by vibrations.
18 | Danfoss A/S © 2022.02
196
(7.72)
242
2 x 100
23.5 (0.93)
(9.53)
(2 x 3.94)
Ø6 (0.24)
12 (0.47)
91.5
(3.60)
11.1.1 Dimensions of the Single-pump Standalone Cooling Module
Module.
Mechanical Installation
5 x 150 = 750 (5 x 0.59 = 29.53)
Ø5.5 x 9.5 (Ø0.22 x 0.37)
23.5
231
(0.93)
(9.09)
12 (0.47)
580.2 (22.84) 97.3
(3.83)
781 (30.75)
797 (31.38)
AQ339830072437en-000202 / 172F0589
248.5 (9.78)
233 (9.17)
225 (8.86)
175 180.5 196
(6.89) (7.11) (7.72)
2 x 100 = 200
(2 x 3.94 = 7.87)
and 11.1.2