Danfoss iC7 Series Operating Manual page 13

iC7 Series Cooling Modules
Operating Guide
4 Receiving the Product
4.1 Checking the Shipment
Procedure
1. Examine the packaging and the cooling module for transport damage.
a. If the cooling module was damaged during transport, contact the cargo insurance company or the carrier.
2. Make sure that the items supplied and the information on the product label correspond to the order confirmation.
a. If the shipment does not match your order, contact the vendor immediately.
4.2 Storing the Cooling Module
If it is necessary to store the product before installing it, follow these instructions. Keep the equipment sealed in its packaging until
installation.
Procedure
1. Make sure that the ambient conditions are within these guidelines:

Temperature: -40...+70 °C (-40...+158 °F)
No humidity
No dust
2. Make sure that there is no coolant in the cooling module.
3.
Plug the inlet and outlet pipes to the cooling module.
4.3 Lifting the Cooling Module
The cooling module is delivered horizontally in a plywood package.
LIFTING HEAVY LOAD
Not following the safe lifting instructions can result in death or serious injury and damage to the equipment.
-
Do not walk under, or place any part of your body under suspended loads.
-
Use lifting devices that are appropriate for the weight of the unit.
-
Use the recommended lifting method.
-
Before lifting the product, check its center of gravity.
SWINGING HAZARD DURING LIFTING
The swing effect can cause serious injury and damage to the equipment. It occurs when lifting the product into a vertical posi-
tion, just before the product reaches vertical position, when the center of gravity of the product surpasses the floor support
point.
-
Make sure that the lifting ropes are properly attached.
-
Secure the lifting area.
-
Lift the product slowly and carefully.
TRANSPORTATION HAZARD
If there is coolant in the cooling module during transportation, low and high ambient temperatures can damage the cooling
module.
-
Move the cooling module empty, that is, without coolant in it.
See the dimensions and the weight of the product in
Lifting the enclosed cooling module
Danfoss A/S © 2022.02
W A R N I N G
W A R N I N G
C A U T I O N
3.3 Outer Dimensions and Weights.
Receiving the Product
AQ339830072437en-000202 / 172F0589 | 13