Resume Embroidering After Turning Off The Machine - Brother PR-600 Manual

Sapphire.book Page 81 Friday, August 1, 2003 9:12 AM

Resume Embroidering After Turning Off the Machine

In either of the following cases, the remaining stitches of the embroidery are stored in the machine's memory.
• If the machine's power switch is pressed to turn off after stopping embroidering.
Cut the thread before the machine's main power switch is turned off, otherwise the thread may be pulled or
may catch when the carriage returns to its initial position after the machine is turned on again.
• If the machine was accidentally turned off, for example, due to a power outage, while it was embroidering.
The remainder of the embroidery can be sewn when the machine is turned on again; however, some of the
stitches that were already sewn may be sewn again.
Note
● Be careful when going back or forward
through the stitching since the embroidery
frame moves at the same time.
1
Set the main power switch to "I" to turn on
the machine.
2
When the screen shown below appears after
the opening screen, touch
A message appears, asking if you wish to
continue embroidering or start a new
operation.

Resume Embroidering After Turning Off the Machine

3
.
81