Brother PR-600 Manual page 200

Sapphire.book Page 182 Friday, August 1, 2003 9:12 AM
Appendix ———————————————————————————————————————————————————————————
0 The bobbin will stop rotating automatically
when it is done winding, and the bobbin
holder will return to its original position.
a Remove the bobbin.
Note
● When removing the bobbin, do not pull on
the bobbin winder seat. Doing so could
loosen or remove the bobbin winder seat,
resulting in damage to the bobbin winder.
b
Pull the thread through the guide slit in the
bobbin winder seat to cut the thread with the
cutter.
182
CAUTION
●
Check that the bobbin thread has been
wound correctly, otherwise the needle
may break or the thread tension will be
incorrect.
■ If bobbin winding is stopped before it is finished:
The bobbin winder stops automatically if the
thread does not feed, for example, if it becomes
tangled on the spool pin. If this occurs, correctly
thread the bobbin winder, and then wind the
bobbin correctly.