Installing The Bobbin; Removing The Bobbin Case - Brother PR-600 Manual

Sapphire.book Page 18 Friday, August 1, 2003 9:12 AM
EMBROIDERING TUTORIAL ———————————————————————————————————————————————————

1. Installing the Bobbin

The bobbin case is loaded with a bobbin wound with embroidery bobbin thread. Remove the bobbin case with
the bobbin, check the amount of thread remaining in the bobbin, and then re-install the bobbin case with the
bobbin. For precautions concerning the bobbin, refer to page 15.
Note
● A function that shows the amount of bobbin
thread remaining is not available with this
machine. Before starting to embroider, be
sure to check the certain amount of bobbin
thread remaining.
● Make sure to clean the bobbin case every
time when change the bobbin. For details
on cleaning the bobbin case, refer to
"Cleaning the bobbin case" on page 185.

Removing the bobbin case

1 Open the hook cover.
Pull the hook cover toward you.
2 Pull the thread picker toward you.
1 Thread Picker
To gain access to the bobbin case easily, pull
the thread picker toward front.
Note
● Thread picker is a device that is used to
hold the thread when begining to sew or
when trimming the thread.
CAUTION
●
The thread picker can only be moved
within a certain range. Do not pull it with
extreme force.
18
3 Grab the bobbin case latch, and remove the
bobbin case.
1 Latch
4
Close the latch, and then remove the bobbin
from the bobbin case.
1
1 Bobbin
5
Check the amount of bobbin thread remaining.
■ Oiling the machine
After removing the bobbin case, apply oil to the
machine. The race should be oiled. For details on
oiling the machine, refer to "Oiling the machine"
on page 186.
● Make sure to oil the race of hook everyday
1
1
Note
when use the machine.