Table of Contents
Advertisement
Resume Embroidering
After Turning Off the
Machine
In either of the following cases, the remaining
stitches of the embroidery are stored in the
machine's memory.
• If the machine's power switch is pressed to turn off
after stopping embroidering.
Cut the thread before the machine's main power
switch is turned off, otherwise the thread may be
pulled or may catch when the carriage returns to its
initial position after the machine is turned on again.
• If the machine was accidentally turned off, for
example, due to a power outage, while it was
embroidering.
The remainder of the embroidery can be sewn when
the machine is turned on again; however, some of the
stitches that were already sewn may be sewn again.
Note
• Be careful when going back or forward
through the stitching since the embroidery
frame moves at the same time.
a
Set the main power switch to "I" to turn on
the machine.
b
When the machine is turned on, the
opening movie is played. Touch anywhere
on the screen to display the message below.
c
Touch
.
A message appears, asking if you wish to continue
embroidering or start a new operation.
OTHER BASIC PROCEDURES
d
Touch
.
1 Touch to cancel embroidering and display the
pattern type selection screen to select a new
pattern.
2 Touch to continue embroidering.
The embroidering screen displayed before the
machine was turned off appears.
e
Touch
.
The stitch navigating screen appears.
1
2
3
101
Advertisement
Table of Contents
Troubleshooting
