Embroidery Cards (Optional) - Brother PR-600 Manual

Sapphire.book Page 109 Friday, August 1, 2003 9:12 AM
■ Deleting embroidery data
From this screen, the embroidery data stored in
the machine's memory can be organized by
deleting unnecessary data.
After selecting the pattern that you wish to delete,
touch to display the screen shown below.
1 Deletes the data, then returns to the data with no
pattern selected.
2 Does not delete the data, then returns to the
screen before
3 Touch .
This confirms the pattern selection.
The pattern editing screen appears.
was touched.

Embroidery cards (optional)

1
Insert the embroidery card into the machine's
embroidery card slot.
With the side of the embroidery card marked
with an arrow facing toward you, fully insert
the card into the embroidery card slot on the
right side of the operation panel.
Note
● Only insert or remove embroidery cards
while appears in the display or
while the embroidery machine is turned off.
● Make sure that the embroidery card is
inserted with the side marked with the
arrow facing toward you, do not insert the
card with extreme force, and do not insert
any object other than embroidery cards into
the slot, otherwise the machine may be
damaged.
● Do not insert the CompactFlash card into
the slot.
● If an embroidery card other than our
original embroidery cards are used, the
embroidery machine may not operate
correctly. Be sure to use only recommended
embroidery cards.
Selecting an Embroidery Pattern
5
109