Troubleshooting - Brother PR-600 Manual

Brother pr-600 sewing machines: users manual
Hide thumbs Also See for PR-600:
Table of Contents

Advertisement

Sapphire.book Page 190 Friday, August 1, 2003 9:12 AM
Appendix ———————————————————————————————————————————————————————————

Troubleshooting

If the machine does not operate correctly, check for the following points/issues before requesting service.
If the suggested remedy does not correct the problem, contact your authorized dealer.
Symptom
The machine is not turned ON.
The machine has not been
unlocked.
The embroidery
machine does not
The start/stop button was not
operate.
pressed.
Upper Tension dial is over
tightened.
The needle is not installed
correctly.
The needle set screw is loose.
The needle is bent or blunt.
The area around the hole in the
needle plate is damaged.
The needle
breaks.
The needle hits/touchs the
needle plate.
The presser foot is set too high
and not correctly positioned.
The needle hits/touches the
presser foot.
190
Probable Cause
Turn on the embroidery machine.
Touch the unlock key.
With the machine unlocked,
press the start/stop button.
Make sure tension disc rotates
when pulling on thread.
Correctly install the needle.
Use the Allen screw driver to
securely tighten the needle set
screw.
Replace the needle with a new
one.
1
Replace the needle plate.
Consult your nearest authorized
dealer.
1 Scratches/Burrs
1
2
Replace needle.
Consult your nearest authorized
dealer.
3
1 Needle
2 Hole in needle plate
3 Needle hits hole
Consult your nearest authorized
dealer.
Remedy
Reference Page
p.15, 61
p.20
p.41
p.41
p.84
p.61
p.61

Advertisement

Table of Contents

Troubleshooting

loading

Table of Contents