Winding/Installing The Bobbin; Winding The Bobbin - Brother 888-L91 Operation Manual

Winding/Installing the Bobbin

Winding/Installing the Bobbin
CAUTION
• Only use the Bobbin (part code: SA156, SFB:
XA5539-151) designed specifically for this
machine. Use of any other bobbin may result
in injuries or damage to the machine.
• The included bobbin was designed specifically
for this machine.
If bobbins from other models are used, the
machine will not operate correctly. Use only
the included bobbin or bobbins of the same
type (part code: SA156, SFB: XA5539-151).
SA156 is Class15 type bobbin.
* Made of plastic
1 This model
2 Other models
3 11.5 mm (approx. 7/16 inch)

Winding the bobbin

This section describes how to wind thread onto a bobbin.
Memo
• When winding bobbin for embroidery be sure to
use the recommended bobbin thread for this
machine.
B-14
a Open the top cover.
b Place the bobbin on the bobbin winder shaft so that the
spring on the shaft fits into the notch in the bobbin
Press down on the bobbin until it snaps into place.
1 Notch
2 Bobbin winder shaft spring
Slide the bobbin winder in the direction of the arrow
c
until it snaps into place.
• The "Start/Stop" button lights up in orange.
d Remove the spool cap that is inserted onto the spool
pin.
2
1 Spool pin
2 Spool cap
.
1
2
1